1 viewer
Fab machine
Virtual printer
A printer keeps the permissive path: pre-flight reports bounds but does not gate a send.
- Kind
- 3D printer (FDM)
- Dialect
- marlin
- Envelope
- 220 × 220 × 250 mm
- Revision
- 1
The web Stop is not an emergency stop. Keep the machine's physical e-stop within reach.
no controller report yet last known
Controls
The strip above refreshes from the running job, or from the last read. Reading an idle controller opens its port, and a board that resets when its port opens (most Arduino-based GRBL controllers) reboots on every read.
Jog and zero appear only while the controller reports Idle and no job is streaming. A step is at most 10 mm; feed is capped at 3000 mm/min and at each axis's own limit.
Profile
| Machine id | virtual-printer |
|---|---|
| Kind | 3D printer (FDM) |
| Controller | marlin |
| Port | simulator://printer |
| Baud | 115200 (default) |
| X envelope | 0 … 220 mm (travel 220 mm, max feed 9000 mm/min) |
| Y envelope | 0 … 220 mm (travel 220 mm, max feed 9000 mm/min) |
| Z envelope | 0 … 250 mm (travel 250 mm, max feed 1200 mm/min) |
| Max spindle | — |
| Laser full-power S | — |
| Homing | yes |
| Probe | no |
| Station | — |
| Owner | nobody (ungated) |
| Revision | 1 |
No tool table: the pre-flight counts tools and tool changes but checks no tool against a table.
Jobs on this machine
No job on this runtime has been pre-flighted on or sent to this machine.